Abstract




 
   

Vol. 12, No. 4 (November 1999) 219-232   

downloaded Downloaded: 55   viewed Viewed: 1715

  INFLUENCE OF OPERATION CONDITIONS UPON THE DYNAMIC STEADY STATE PERFORMANCE OF SWITCHED RELUCTANCE MOTOR
 
 
J. Faiz
 
Department of Electrical and Computer Engineering
Faculty of Engineering
University of Tehran
Tehran, Iran
 
 
E. Shafegh
 
Department of Electrical Engineering
Faculty of Engineering
University of Tabriz
Tehran, Iran
 
 
 
( Received: October 01, 1998 – Accepted in Revised Form: April 08, 1999 )
 
 

Abstract    In order to obtain more accurate predicted dynamic steady-state performance with shorter computation time, an available mathematical model is modified and presented. Using this modified model, performance of a typical switched reluctance motor (SRM) under a wide range of variations of operating conditions is obtained and discussed. These include variations of speed, voltage, load and switching angle. The static test characteristics of the motor are carefully measured and the measured flux-linkage data are then used to predict the steady-state performance.

 

Keywords    Switched Reluctance Motor, Dynamic Performance, Performance Prediction Techniques

 

References   

 
1. P. J. Lawrenson, et al., "Variable Speed Switched Reluctance Motors", proc. IEE, Pt. B, Vol. 127, No. 4, (July 1980), 253-265.
2. P. N. Materu and R. Krishnan, "Steady-state Analysis of the Variable Speed Switched Reluctance Motor", IEEE Trans. On Industrial Electronics, Vol. 36, (Nov. 1989), 523-529.
3. H. Le Huy, P. Viarogue and P. Francocur, "Unipolar Converters for switched Reluctance Motors", In rec. (1989), IEEE Industry Applications Soc. Ann. Meeting, 551-560.
4. J. T. Bass, et al., "Development of Unipolar Converter for Variable Reluctance Motor Drives", IEEE Trans. on Industry Applications, Vol. IA-23, (May/June 1987), 545-553.
5. W. F. Ray and R.M. Davis, "Inverter Drive for Doubly-Salient Reluctance Motors, its Fundamental Behavior, Linear Analysis and Cost Implication", Proc. IEE, Pt. B. No. 6, 185-193.
6. Ilic-Spong et al., "Nonlinear torque control of electric motor drives-part II", PESC Record, (1986), 456-475.
7. I. E. D. Pickup and D. Tipping, "Method for Predicting the Dynamic Response of a variable Reluctance Stepping Motor", Proc. IEE, Vol. 120, No. 7, (July 1973), 757-764.
8. I. E. D. Pickup and D. Tipping, "Prediction of Pull-Out Rate and Settling Time Characteristics of a Variable Reluctance Stepping Motor and Effect of Stator Damping Coils on these Charactristics, Proc. IEE, Vol. 123, No. 3, (march 1979), 213-219.
9. J. W. Finch, H. M. B. Metwally, "Performance Prediction of Saturated Variable Reluctance and Hybrid Motors", International Conference of Power Electronics and Variable Speed Drives, London, (September 1989), 231-236.
10. D. A. Torrey, J. N. Lang, "Modeling a nonlinear Variable-Reluctance Motor Drive", IEE Proc., Vol. 137, Pt. B. No. 5, (September 1990), 314-326.
11. J. Faiz, "A Review of the Performance Prediction and Design Techniques for Switched Reluctance Motors", Journal of Electrical and Electronics Engineering, Australia, Vol. 12, No. 3, (September 1992), 258-266.
12. J. Corda and J. M. Stephenson, "Computation of Torque and Current in Doubly-Salient Reluctance Motors from Nonlinear Magnetization Data", Proc. IEE, Vol. 126, (May 1979), 393-396.
13. J. Faiz, J. W. Finch and H. M. B. Metwally, "A Novel Switched Reluctance motor with Multiple Teeth Per stator Pole and Comparison of such Motors", International journal of Electric Power Systems Research, Vol. 34, (1995), Elsevier, 197-203.
14. S. Haykin, "Adaptive Filter Theory", Printice Hall, London, (1991).
15. M. R. Harris, et al., "A Review of the Integral-Horsepower Switched Reluctance Drive", IEEE Trans. On Industry Applications, Vol. IA-22, No. 4, (July/August 1986), 716-721.
16. M. R. Harris et al., "Discussion on Variable- Speed Switched Reluctance Motor Systems", IEE Proc. Pt. B, 128, (1981), 260-268.
17. H. M. B. Metwally, J. Faiz and J. W. Finch, "Core loss in Switched Reluctance Motor Structure-Experimental Results", Proc. Of International Conference of Electrical Machine (ICEM-88), (Sept. 1988), Pisa, Italy, Vol. II, 31-34.
18. J. R. French, "Switched Reluctance Motor Drives for Rail Traction Relative Assessment", IEE Proc., Part B, Vol. 131, No. 5, (September 1984), 209-219.
19. T. J. E. Miller, J. T. Bass and M. Ehsani, "Stabilization of VRMD Operating Without Shaft Position Feedback", 14th Symposium Incr. Motion Control System & Devices, University of Illinois, (1985), 361-367.








International Journal of Engineering
E-mail: office@ije.ir
Web Site: http://www.ije.ir